Designed and Manufactured by Davaran Fydar Maham
Design and Application of the Vertical Tank
The 5000-liter vertical tank, with an approximate height of 2 meters and a radius of 1.7 meters, is ideal for locations where height clearance is not an issue.
Due to its smaller footprint, this type of tank is highly efficient in spaces with limited horizontal area.
Reinforced Strength with Fin Design
The tank’s design includes reinforcement fins on the walls to:
- Increase structural strength
- Prevent deformation or “bulging” of the tank under liquid pressure
Material and Benefits of Polyethylene Tanks
The 5000-liter vertical tank is made of polyethylene.
This material, due to its numerous advantages, is an ideal choice for manufacturing both industrial and domestic storage tanks.
Advantages of Using Polyethylene
- Low-cost raw materials due to domestic production
- Suitable for storing drinking water
- No chemical interaction with the contents of the tank
- Resistant to ultraviolet (UV) radiation penetration
- High resistance to brittleness and mechanical stress
- Easy and convenient repair of damaged areas
- Suitable for use in any weather condition due to high expansion and contraction coefficient
Mold Fabrication and Production Process
The rotational mold for the 5000-liter vertical tank is made from ST37 steel sheet.
This mold is manufactured with high precision and in accordance with industrial standards.
Advanced Mold Features
- Integrated metal inserts for embedding brass fittings
- Option for plastic fittings upon customer request
- Threaded insert in the tank lid for secure cap installation
- Ability to register the customer’s brand on the final product in raised or recessed form
Mold Production Steps
- Bending steel sheets with high precision
- Welding components to form the initial mold shape
- Machining surfaces to achieve required accuracy
- Polishing the inner surface of the mold to produce a tank with the best exterior finish
- Delivering the ready mold to the production line or customer
Specialized Service: Turning Ideas into Products
Sometimes you may have an idea or a preliminary design for a product, but face technical challenges in bringing it to life.
Davaran Fydar Maham, with over 15 years of experience in rotational molding and mold fabrication, is ready to assist you.
Steps to Turn an Idea into a Product
- Receiving the customer’s idea or initial drawing
- 3D modeling of the product by engineers
- Design corrections and optimizations to improve strength and durability
- Simulation and performance analysis under real conditions
- Predicting and resolving potential defects before mass production
- Final approval from the customer and supervising engineer
- Mold production and start of mass production
This process is designed to prevent economic losses and wasted time for both parties.